Rvinyl Headlight, Tail Light and Fog Light Tint Film kits are model-specific pre-cut kit designed to make your vehicle stand out from the crowd. These urethane based protection kits bond to your car''s headlights with optically clear non-permanent adhesive. Designed to conform to the contours of your vehicle''s lighting when heated, our tint kits are the most seamless light modifications available on the automotive market today. Scratch resistant with up to five years of outdoor durability, there is no better way to modify or protect your car''s primary light housings then with this "fusion product." Smoked Headlight Kits are pre-cut and model specific and made from a pliable urethane adhesive backed film. Rvinyl kits apply as easily as a decal, but are repositionable during the application process (kits become fully bonded after 48 - 72 hours and are no longer repositionable). Convenient placement tabs are included to aid in application alignment and trimmed off after application. Application squeegee and detailed installation instructions are included. Detailed installation instructions are included with each kit. Non-Protective Tint Film Properties: Thickness of film plus adhesive: .0042" (0.010668cm) Application temperature: 50°F to 104°F (10°C - 40°C) Rvinyl recommends an application temperature of 70-80°F (21° -26°) End Use temperature after application: -35°F to 300°F (-37.2°C - 148.8°C) Non-Protective Tint Film Light Transmission Percentages: Amber Translucent Film: 20% Light Transmission Blue Non-Protective Film: 83% Light Transmission Lime Non-Protective Film: 70% Light Transmission Red Non-Protective Film: 87% Light Transmission Smoke (Dark) Non-Protective Film: 67% Light Transmission Smoke (Light) Non-Protective Film: 87% Light Transmission Yellow Smoke Non-Protective Film: 86% Light Transmission"